![]() That's easily explained, though the answer won't help much. I just took the front off and moved the hour handĬan't understand why its not picking up what should be a stronger local signal ? We bought one for work years ago, and it showed ET. Not sure what I will do with the 2nd one. The only neat clocks I could find showed European time. Why bother? There are some pretty disgusting designs about. I might have to thin the retaining nut down a touch but all's ok so far. Only problem is that it's a bit deeper than the type that was in and the stub for the hour hand is a little on the short size and needed pressing on dead square to hold. I did look at dismantling the old one but couldn't get completely down to the circuit board.Īs it didn't sync well with the signal from Germany I bought one that uses the UK signal. Turns out that the hand fittings go by the name of push fit and there are plenty about. The part that does all of the work is a small square block on the back of the clock. This one used to take some time to sync from new. Just refuse to sync to time unless it was horizontal and just kept spinning. We have a couple of these and one went crazy.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |